Konica Minolta bizhub 160 Service Manual - Page 245
Soft Switch: #38, Soft Switch: #39
View all Konica Minolta bizhub 160 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 245 highlights
bizhub 160/160f bizhub 161/161f 16. Soft Switch Set (bizhub 160f/bizhub 161f only) 16.8.38 SOFT SWITCH: #38 Field Service Ver. 1.0 Apr. 2005 Bit Designation No. Function 8 Fine tune of 33.6 kbps/ 0: No - modem default setting 31.2 kbps receiving 1: Yes speed for V.34 modem 7 Set/Reset V.34 trans- 0: Reset mit level deviation 1: Set 6 V.34 flag number 5 between ECM frame Flags number Bit 6 Bit 5 2 4 0 0 0 1 Initial Setting Bit HEX 1E 1 8 10 1 1 1 0 0 1 4 Phase 2 guard tone power level (V.34) 0: normal power level 1: -7 db of normal power level 3 Reserved Reserved 2 Polling RX start speed 0: start from V.34 1: start from V.17 1 V.8 /V.34 capability 0: No 1: Yes 01 0 0 1 • Bit 8: This bit when set to 1 can get higher speed communication for V.34 under the same line condition. 16.8.39 SOFT SWITCH: #39 Bit Designation No. Function 8 Disable V.34 TX for V.34 modem 0: No 1: Yes 7 Disable V.34 RX for V.34 modem 0: No 1: Yes 6 Flags number in ECM 5 frame for V.34 modem Flags number Bit 6 Bit 5 1 2 3 4 0 0 1 1 0 1 0 1 4 Manual TX mode for V.34 modem 0: V.8 - start handshake from V.8 1: V.17 3 Switch from V.17 to 0: Yes - start V.8 handshaking.but only first time V.34 if DIS bit 6 set after 1: No - Continue start with V.17 received DIS 2 Delay time in primary Symbol rate (ms) 100 200 300 500 1 channel for V.34 trans- Bit 2 0 0 1 1 mit after CFR or MCF signal Bit 1 0 1 0 1 Initial Setting Bit HEX 00 0 0 0 01 0 0 1 Adjustment / Setting 212