Lenovo ThinkCentre M76 Hardware Maintenance Manual for ThinkCentre M76 - Page 70
POST Error code, POST Error message, Description/Action, Security EEPROM Block 6 is corrupted.
View all Lenovo ThinkCentre M76 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
POST Error code 0135 0211 0164 0662 1762 1820 1962 0162 0175 0176 POST Error message Fan failure Description/Action The system might be overheating. Press F1 to enter the Setup Utility program. Then press F10 to save and exit the Setup Utility program. Keyboard not found Memory size decreased Note: If the problem is caused by the microprocessor fan, pressing F10 will not solve the problem. This error message is displayed when there is no keyboard detected. This error message is displayed when the memory size has decreased. Configuration change has occurred Press F1 to enter the Setup Utility program. Then press F10 to save and exit the Setup Utility program. This error message is displayed when a floppy drive change has been made. Configuration change has occurred Press F1 to enter the Setup Utility program. Then press F10 to save and exit the Setup Utility program. This error message is displayed when a hard disk drive or optical drive change has been made. Press F1 to enter the Setup Utility program. Then press F10 to save and exit the Setup Utility program. More than one external fingerprint reader is attached. Power off and remove all but the reader that you set up within your main operating system. If more than one external fingerprint reader is connected to a computer, this error message will be displayed to inform you to remove all of the fingerprint keyboards except the one compatible with the fingerprint application on your computer. No operating system found. Press any key This error occurs only after the POST is completed. to repeat boot sequence. Press any key to repeat boot sequence. Setup data integrity check failure Press F1 to enter the Setup Utility program. Then press F10 to save and exit the Setup Utility program. System Security - Security data corrupted This error indicates that the data stored in the Security EEPROM Block 6 is corrupted. System Security - The system has been tampered with Press F1 to enter the Setup Utility program. Then press F10 to save and exit the Setup Utility program. This error message is displayed when the computer is turned on with the cover open or removed. Press F1 to enter the Setup Utility program. Then press F10 to save and exit the Setup Utility program. 66 ThinkCentre Hardware Maintenance Manual