Lenovo ThinkCentre M90z (English) User Guide - Page 37
Partially tighten screw
View all Lenovo ThinkCentre M90z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
6. Follow this sequence to remove the four screws that secure the heat sink to the system board: a. Partially remove screw 1 , then fully remove screw 2 , and then fully remove screw 1 . b. Partially remove screw 3 , then fully remove screw 4 , and then fully remove screw 3 . Note: Carefully remove the four screws from the system board to avoid any possible damage to the system board. The four screws cannot be removed from the heat sink. Figure 23. Removing the heat sink 7. Lift the failing heat sink off the system board. Notes: a. You might have to gently twist the heat sink to free it from the microprocessor. b. Do not touch the thermal grease while handling the heat sink. 8. Position the new heat sink on the system board so that the four screws are aligned with the corresponding holes in the system board. 9. Follow this sequence to install the four screws to secure the heat sink, as shown in Figure 23 "Removing the heat sink" on page 29. a. Partially tighten screw 1 , then fully tighten screw 2 , and then fully tighten screw 1 . b. Partially tighten screw 3 , then fully tighten screw 4 , and then fully tighten screw 3 . 10. To reinstall the fan duct, position the fan duct on the heat sink and then press the fan duct downward until the two tabs on the fan duct are secured into place. What to do next: • To work with another piece of hardware, go to the appropriate section. • To complete the installation or replacement, go to "Completing the parts replacement" on page 50. Chapter 2. Installing or replacing hardware 29