Lexmark MS911 User's Guide - Page 103
Show Bookmarks, Web Refresh Rate, Contact Name, Location, Alarms, Notes, Timeouts
View all Lexmark MS911 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Understanding the printer menus Use Show Bookmarks Yes No Web Page Refresh Rate 30-300 Contact Name Location Alarms Alarm Control Cartridge Alarm Staple Alarm Hole Punch Alarm Timeouts Standby Mode Disabled 1-240 Timeouts Sleep Mode Disabled 1-120 Timeouts Print with Display off Allow printing with display off Display on when printing 103 To Specify whether bookmarks are displayed from the Held Jobs area. Note: Yes is the factory default setting. Specify the number of seconds between Embedded Web Server refreshes. Note: 120 is the factory default setting. Specify a contact name for the printer. Note: The contact name is stored on the Embedded Web Server. Specify the location of the printer. Note: The location is stored on the Embedded Web Server. Set an alarm when the printer requires user intervention. For each alarm type, select from the following options: Off Single Continuous Notes: • Off is the factory default setting for Cartridge Alarm, Staple Alarm, and Hole Punch Alarm. • Single is the factory default setting for Alarm Control. This sounds three quick beeps. • Continuous repeats three beeps every 10 seconds. Specify the number of minutes of inactivity before the printer enters a lower power state. Note: 15 is the factory default setting. Set the amount of time in minutes the printer waits after a job is printed before it goes into a reduced power state. Notes: • 20 is the factory default setting. • Disabled appears only when Energy Conserve is set to Off. • Lower settings conserve more energy, but may require longer warm‑up times. • Select a high setting if the printer is in constant use. Under most circumstances, this keeps the printer ready to print with minimum warm‑up time. Allow the printer to print even when the display is off. Note: Allow printing with display off is the factory default setting.