Lexmark MS911 User's Guide - Page 79

Understanding the printer menus 79 Use Portrait Width 3.54-48 inches 89.9-1219 mm Portrait Height 5.5-48 inches 139.7-1219 mm Feed Direction Short Edge Long Edge To Set the portrait width. Notes: • If the width exceeds the maximum, then the printer uses the maximum width allowed. • 12 inches is the U.S. factory default setting. You can increase the width in 0.01‑inch increments. • 305 mm is the international factory default setting. You can increase the width in 1‑mm increments. Set the portrait height. Notes: • If the height exceeds the maximum, then the printer uses the maximum height allowed. • 17 inches is the U.S. factory default setting. You can increase the height in 0.01‑inch increments. • 432 mm is the international factory default setting. You can increase the height in 1‑mm increments. Specify the feed direction if the paper can be loaded in either direction. Notes: • Short Edge is the factory default setting. • Long Edge appears only when the longest edge is shorter than the maximum width supported in the tray. Bin Setup menu Use To Output Bin Standard Bin Bin [x]* Specify the default bin. Note: Standard Bin is the factory default setting. Configure Bins Mailbox Link Link Optional Type Assignment Specify configuration options for bins. Notes: • Mailbox is the factory default setting. This treats each bin as a separate mailbox. • Link configures all available bins as one large bin. • Link Optional links together all available bins except the standard bin and only appears when at least two optional bins are installed. • Type Assignment assigns each paper type to a bin or linked bin set. * [x] can be any number from 1 to 4 if the appropriate optional bins are installed. If multiple bins are assigned the same name, then the name appears only once in the bin list.