Lexmark MS911 User's Guide - Page 107

Understanding the printer menus 107 Use Paper Source Tray [x] MP Feeder Manual Paper Collate (1,1,1) (2,2,2) (1,2,3) (1,2,3) Sides (Duplex) 1 sided 2 sided Staple Off On Hole Punch Off On Hole Punch Mode 2 holes 3 holes 4 holes Duplex Binding Long Edge Short Edge Paper Saver Orientation Auto Landscape Portrait To Set a default paper source for all print jobs. Note: Tray 1 is the factory default setting. Stack the pages of a print job in sequence when printing multiple copies. Note: "(1,2,3) (1,2,3)" is the factory default setting. Specify whether prints are on one side or on both sides of the page. Note: 1 sided is the factory default setting. Specify whether prints are stapled. Notes: • Off is the factory default setting. • On allows the printer to staple print jobs. • This menu appears only when a supported staple finisher is installed. Specify whether prints have holes for binding. Notes: • Off is the factory default setting. • This menu appears only when a supported staple, hole punch finisher is installed. Specify the number of holes to be made on the prints. Notes: • "3 holes" is the U.S. factory default setting. "4 holes" is the international factory default setting. • This menu appears only when a supported staple, hole punch finisher is installed. Define the way duplexed pages are bound and printed. Notes: • Long Edge assumes binding along the long edge of the page (left edge for portrait and top edge for landscape). This is the factory default setting. • Short Edge assumes binding along the short edge of the page (top edge for portrait and left edge for landscape). Specify the orientation of a multiple‑page document. Notes: • Auto is the factory default setting. • This setting affects jobs if the value of the Paper Saver setting in the same menu is not set to Off.