Lexmark MS911 User's Guide - Page 193

Troubleshooting 193 Paper changes needed Try one or more of the following: • Touch Use current supplies to clear the message and continue printing. • Cancel the current print job. Parallel port [x] disabled [56] Try one or more of the following: • From the printer control panel, touch Continue to clear the message. • Enable the parallel port. From the printer control panel, navigate to: Network/Ports > Parallel [x] > Parallel Buffer > Auto Note: The printer discards any data received through the parallel port. Photoconductor low [84.xy] You may need to order a replacement photoconductor. If necessary, select Continue on the control panel to clear the message and continue printing. Photoconductor very low [84.xy] You may need to replace the photoconductor unit very soon. For more information, see "Replacing a photoconductor unit" on page 136. If necessary, touch Continue on the control panel to clear the message and continue printing. Printer had to restart. Last job may be incomplete. From the printer control panel, touch Continue to clear the message and continue printing. For more information, visit http://support.lexmark.com or contact customer support. Reinstall missing or unresponsive cartridge [31.xy] Try one or more of the following: • Check if the toner cartridge is missing. If missing, install the toner cartridge. For information on installing the cartridge, see the "Replacing supplies" section of the User's Guide. • If the toner cartridge is installed, then remove the unresponsive toner cartridge, and then reinstall it. Note: If the message appears after reinstalling the supply, then the cartridge is defective. Replace the toner cartridge.