Netgear M5300-28G3 Web Management User Guide - Page 171

ProSafe M5300 Switch MLD Snooping Querier Configuration Use this menu to configure the parameters for MLD Snooping Querier. Note that only a user with Read/Write access privileges may change the data on this screen. To access the MLD Snooping Querier Configuration page, click Switching Multicast  MLD Snooping  Querier Configuration. 1. Use Querier Admin Mode to select the administrative mode for MLD Snooping for the switch. The default is disable. 2. Use Querier Address to specify the Snooping Querier Address to be used as source address in periodic MLD queries. This address is used when no address is configured on the VLAN on which query is being sent. The supported IPv6 formats are x:x:x:x:x:x:x:x and x::x. 3. Use MLD Version to specify the MLD protocol version used in periodic MLD queries. MLD queries. 4. Use Query Interval(secs) to specify the time interval in seconds between periodic queries sent by the snooping querier. The Query Interval must be a value in the range of 1 and 1800. The default value is 60. 5. Use Querier Expiry Interval(secs) to specify the time interval in seconds after which the last querier information is removed. The Querier Expiry Interval must be a value in the range of 60 and 300. The default value is 60. Field VLAN Ids Enabled For MLD Snooping Querier Description Displays VLAN Ids enabled for MLD snooping querier. Configuring Switching Information 171