Netgear M5300-28G3 Web Management User Guide - Page 228
Receive Version, RIP-1, RIP admin mode, Authentication Type, Simple, Encrypt, APPLY, REFRESH, CANCEL
View all Netgear M5300-28G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 228 highlights
ProSafe M5300 Switch 3. Use Receive Version to select what RIP control packets the interface will accept from the pull-down menu. The value is one of the following: • RIP-1 - Accept only RIP version 1 formatted packets. • RIP-2 - Accept only RIP version 2 formatted packets. The default is RIP-2. • Both - Accept packets in either format. • None - No RIP control packets will be accepted. 4. Use RIP admin mode to enable RIP for an interface. The default is Disable. 5. Use Authentication Type to select an authentication type other than none by clicking on the 'Configure Authentication' button. You will then see a new screen, where you can select the authentication type from the pull-down menu. The choices are: • None - This is the initial interface state. If you select this option from the pull-down menu on the second screen you will be returned to the first screen and no authentication protocols will be run. • Simple - If you select 'Simple' you will be prompted to enter an authentication key. This key will be included, in the clear, in the RIP header of all packets sent on the network. All routers on the network must be configured with the same key. • Encrypt - If you select 'Encrypt' you will be prompted to enter both an authentication key and an authentication ID. Encryption uses the MD5 Message-Digest algorithm. All routers on the network must be configured with the same key and ID. 6. Use Authentication Key to enter the RIP Authentication Key for the specified interface. If you do not choose to use authentication you will not be prompted to enter a key. If you choose 'simple' or 'encrypt' the key may be up to 16 octets long. The key value will only be displayed if you are logged on with Read/Write privileges. 7. Use Authentication Key ID to enter the RIP Authentication Key ID for the specified interface. If you choose not to use authentication or to use 'simple' you will not be prompted to enter the key ID. If you choose 'encrypt' the key ID may be in range from 0 to 255. The key ID value will be displayed only if you are logged on with Read/Write privileges. 8. Click APPLY to update the switch with the changes. 9. Click REFRESH to update the screen with the most recent information. 10. Click CANCEL to abandon the changes. RIP Status Field Interface IP Address Description Displays the interface for which data is configured. Displays the IP Address of the router interface. Routing 228