Netgear M5300-28G3 Web Management User Guide - Page 255

ProSafe M5300 Switch Route Redistribution This screen can be used to configure the OSPF Route Redistribution parameters. The allowable values for each fields are displayed next to the field. If any invalid values are entered, an alert message will be displayed with the list of all the valid values. To display the Route Redistribution page, click Routing OSPF Advanced  Route Redistribution. To configure OSPF route redistribution: 1. Use Source to list available source routes that have not previously been configured for redistribution by OSPF. The valid values are 'Static', 'Connected', and 'RIP'. 2. Use Redistribute Option to enable or disable the redistribution for the selected source protocol. 3. Use Metric to set the metric value to be used as the metric of redistributed routes. This field displays the metric if the source was pre-configured and can be modified. The valid values are 0 to 16777214. 4. Use Metric Type to set the OSPF metric type of redistributed routes. 5. Use Tag to set the tag field in routes redistributed. This field displays the tag if the source was pre-configured, otherwise 0 and can be modified. The valid values are 0 to 4294967295. 6. Use Subnets to set whether the subnetted routes should be redistributed. 7. Use Distribute List to set the Access List that filters the routes to be redistributed by the destination protocol. Only permitted routes are redistributed. If this command refers to a non-existent access list, all routes are permitted. The valid values for Access List IDs are 1 to 199. When used for route filtering, the only fields in an access list that get used are: • Source IP Address and netmask • Destination IP Address and netmask • Action (permit or deny) All other fields (source and destination port, precedence, ToS, and so on) are ignored. Routing 255