Netgear XSM4324FS Software Administration Manual Software Version 12.x - Page 148

M4300 Series and M4300-96X Fully Managed Switches e. Click Apply to save the settings. 5. Enable OSPF on VLAN 20. a. Select Routing > OSPF > Advanced > Interface Configuration. A screen similar to the following displays. b. Under Interface Configuration, click VLANS to show all the VLAN interfaces. c. Scroll down and select the interface 0/2/2 check box. Now 0/2/2 appears in the Interface field at the top. d. Enter the following information: • In the OSPF Area ID field, enter 0.0.0.3. • In the OSPF Admin Mode field, select the Enable. • In the Priority field, enter 255. • In the Metric Cost field, enter 64. e. Click Apply to save the settings. OSPFv3 OSPFv3 is the Open Shortest Path First routing protocol for IPv6. It is similar to OSPFv2 in its concept of a link state database, intra- and inter-area, and AS external routes and virtual links. It differs from its IPv4 counterpoint in a number of respects, including the following: Peering is done through link-local addresses; the protocol is link based rather than network based; and addressing semantics have been moved to leaf LSAs, which eventually allow its use for both IPv4 and IPv6. Point-to-point links are also supported in order to enable operation over tunnels. It is possible to enable OSPF and OSPFv3 at the same time. OSPF works with IPv4, and OSPFv3 works with IPv6. The following example shows how to configure OSPFv3 on a IPv6 network. OSPF 148 Software Administration Manual