Netgear XSM4324FS Software Administration Manual Software Version 12.x - Page 169

M4300 Series and M4300-96X Fully Managed Switches 4. Assign virtual router IDs to port that will participate in the protocol. (Netgear Switch) (Config)#interface 1/0/4 (Netgear Switch) (Interface 1/0/4)#ip vrrp 20 5. Specify the IP address that the virtual router function will recognize. Since the virtual IP address on port 1/0/4 is the same as Router 1's port 1/0/2 actual IP address, this router will always be the VRRP backup when Router 1 is active. (Netgear Switch) (Interface 1/0/4)#ip vrrp 20 ip 192.150.2.1 6. Set the priority for the port. The default priority is 100. (Netgear Switch) (Interface 1/0/4)#ip vrrp 20 priority 254 7. Enable VRRP on the port. (Netgear Switch) (Interface 1/0/4)#ip vrrp 20 mode (Netgear Switch) (Interface 1/0/4)#exit (Netgear Switch) (Config)#exit Local Browser Interface: Configure VRRP on a Backup Router 1. Enable IP routing on the switch. a. Select Routing > IP > IP Configuration. A screen similar to the following displays. b. For Routing Mode, select the Enable radio button. c. Click Apply to save the settings. 2. Assign IP address 192.150.4.1 to port 1/0/4. a. Select Routing > IP > Advanced > IP Interface Configuration. VRRP 169 Software Administration Manual