Netgear XSM4324FS Software Administration Manual Software Version 12.x - Page 488

M4300 Series and M4300-96X Fully Managed Switches e. Under DHCP Pool Configuration, enter the following information: • In the Pool Name list, select Create. • In the Pool Name field, enter pool_dynamic. • In the Type of Binding list, select Dynamic. • In the Network Number field, enter 192.168.100.0. • In the Network Mask field, enter 255.255.255.0. As an alternate, you can enter 24 in the Network Prefix Length field. Do not fill in both the Network Mask field and Network Prefix Length fields. • In the Days field, enter 1. f. Click Add. The pool_dynamic name is now added to the Pool Name drop-down list. Configure a DHCP Server that Assigns a Fixed IP Address The following example shows how to set up a DHCP server with an IP address pool and let the DHCP server assign a fixed IP address based on a MAC address. The example is shown as CLI commands and as a local browser interface procedure. CLI: Configure a DHCP Server that Assigns a Fixed IP Address (Netgear Switch)#config (Netgear Switch) (Config)#service dhcp (Netgear Switch) (Config)#ip dhcp pool pool_manual (Netgear Switch) (Config-dhcp-pool)#client-name dhcpclient (Netgear Switch) (Config-dhcp-pool)#hardware-address 00:01:02:03:04:05 (Netgear Switch) (Config-dhcp-pool)#host 192.168.200.1 255.255.255.0 (Netgear Switch) (Config-dhcp-pool)#client-identifier 01:00:01:02:03:04:05 Note: The unique identifier is a concatenation of the media type and MAC addresses. For example, the Microsoft client identifier for Ethernet address c8:19:24:88:f1:77 is 01:c8:19:24:88:f1:77, where 01 represents the Ethernet media type. For more information, see the "Address Resolution Protocol Parameters" section of RFC 1700. DHCP Server 488 Software Administration Manual