Netgear XSM4324FS Software Administration Manual Software Version 12.x - Page 466

M4300 Series and M4300-96X Fully Managed Switches When you add a preconfigured switch to the switch stack, the stack applies either the preconfigured configuration or the default configuration. The following table lists the events that can occur when the switch stack compares the preconfigured configuration with the new switch. Table 4. Preconfigured switches compared to stack configuration Switch Type Is Stack Member Number Result the Same Yes Is the same The switch stack applies the configuration to the preconfigured new switch and adds it to the stack. Yes Does not match • The switch stack applies its default stack member number to the preconfigured switch and adds it to the stack. • The stack member number configuration in the preconfigured switch changes to reflect the new information. Is not found in the stack • The switch stack applies the default configuration to the new configuration switch and adds it to the stack. • The preconfigured information is changed to reflect the new information. Is not found in the preconfigured switch The switch stack applies the default configuration to the preconfigured switch and adds it to the stack. Renumber Stack Members This example is provided as CLI commands and a local browser interface procedure. CLI: Renumber Stack Members Note: When you issue a command such as move management or renumber, NETGEAR recommends that you wait until the command fully executes before issuing the next command. For example, after you issue a reset command for a stack member, issue the show port command to verify that the switch remerged with the stack and that all ports joined before you issue a next command. • If specific numbering is required, NETGEAR recommends that you assign stack members their numbers when they are first installed and configured in the stack. • If the stack unit number for a switch is unused, you can renumber the unit by issuing the switch renumber global config mode command. • If you preconfigured the new unit ID, you might need to remove the new unit ID from the configuration before renumbering the unit. Switch Stacks 466 Software Administration Manual