Netgear XSM4324FS Software Administration Manual Software Version 12.x - Page 321

M4300 Series and M4300-96X Fully Managed Switches Create a Static Address The example is shown as CLI commands and as a local browser interface procedure. CLI: Create a Static Address (Netgear Switch) (Interface 1/0/1)#port-security mac-address 00:13:00:01:02:03 Local Browser Interface: Create a Static Address 1. Select Security > Traffic Control > Port Security > Static MAC address. A screen similar to the following displays. 2. Under Port List, in the Interface list, select 1/0/1. 3. In the Static MAC Address section of the screen, enter the following information: • In the Static MAC Address field, enter 00:13:00:01:02:03. • In the Vlan ID list, select 3. 4. Click Add. Protected Ports This section describes how to set up protected ports on the switch. Some situations might require that traffic is prevented from being forwarded between any ports at Layer 2 so that one user cannot see the traffic of another user on the same switch. Protected ports can: • Prevent traffic from being forwarded between protected ports. • Allow traffic to be forwarded between a protected port and a non-protected port. In following example, PC 1 and PC 2 can access the Internet as usual, but PC 1 cannot see the traffic that is generated by PC 2, that is, no traffic is forwarded between PC 1 and PC 2. Security Management 321 Software Administration Manual