Netgear XSM4324FS Software Administration Manual Software Version 12.x - Page 85

M4300 Series and M4300-96X Fully Managed Switches Add a Static Route When the switch performs IP routing, it forwards the packet to the default route for a destination that is not in the same subnet as the source address. However, you can set a path (static route) that is different than the default route if you prefer. The following procedure shows how to add a static route to the switch routing table. CLI: Show Routing Information The following commands assume that the switch already has a defined a routing interface with a network address of 10.10.10.0, and is configured so that all packets destined for network 10.10.100.0 take the path of routing port. (FSM7328S) #show ip route Total Number of Routes 1 Network Address ---------10.10.10.0 Subnet Mask 255.255.255.0 Protocol -------Local Next Hop Intf ---------1/0/3 Next Hop IP Address ----------10.10.10.1 To delete the static route, simply add the no keyword in the front of the ip route command. Local Browser Interface: Add a Static Route 1. Select Routing > Routing Table > Basic > Route Configuration. A screen similar to the following displays. 2. In the Route Type list, select Static. 3. Fill in the Network Address field. Port Routing 85 Software Administration Manual