Netgear XSM4324FS Software Administration Manual Software Version 12.x - Page 318

M4300 Series and M4300-96X Fully Managed Switches Set the Dynamic and Static Limit on Port 1/0/1 The example is shown as CLI commands and as a local browser interface procedure. CLI: Set the Dynamic and Static Limit on Port 1/0/1 (Netgear Switch) (Config)#port-security Enable port-security globally (Netgear Switch) (Config)#interface 1/0/1 (Netgear Switch) (Interface 1/0/1)#port-security Enable port-security on port 1/0/1 (Netgear Switch) (Interface 1/0/1)#port-security max-dynamic 10 Set the dynamic limit to 10 (Netgear Switch) (Interface 1/0/1)#port-security max-static 3 Set the static limit to 3 (Netgear Switch) (Interface 1/0/1)#ex (Netgear Switch) (Config)#ex (Netgear Switch) #show port-security 1/0/1 Admin Dynamic Static Violation Intf Mode Limit Limit Trap Mode ---------- --------- ---------- 1/0/1 Disabled 10 3 Disabled Local Browser Interface: Set the Dynamic and Static Limit on Port 1/0/1 1. Select Security > Traffic Control > Port Security >Port Administrator. A screen similar to the following displays. b. Under Port Security Configuration, next to Port Security Mode, select the Enable radio button. c. Click Apply to save the settings. Security Management 318 Software Administration Manual