Netgear XSM4324FS Software Administration Manual Software Version 12.x - Page 157

M4300 Series and M4300-96X Fully Managed Switches The route map with a deny statement uses the following logic: • The incoming packet is matched against the criteria in the match term specified in the route map. This match command can refer to an IP/MAC access list. An ACL that is used in the match term itself has one or more permit or deny rules. Now, the incoming packet is matched against the rules in the ACL, and a permit or deny decision is reached. • If the decision reached in the previous step is permit, then policy-based routing processing logic terminates and the packet goes through standard destination-based routing logic. • If the decision reached in the earlier step is deny, the counter for this match statement is not incremented and the processing logic moves to next route-map statement in the sequence. If no next route-map statement exists, the processing logic terminates and the packet goes through standard destination-based routing logic. The following table specifies the desired actions: Table 2. Desired actions ACL Permit Permit Permit Permit Deny Deny Deny Deny Match Yes No Yes No Yes No Yes No Outcome Permit Deny Permit Deny Deny Deny Deny Deny Route Map Action Permit Set Permit Next Deny Route Deny Next Permit Next Permit Next Deny Next Deny Next The following actions are taken: • Next. Fall through to the next route map, and if no further route maps exist, route using the default routing table. • Set. Route according to the action in the set clause. • Route (alone). Route using the default routing table. PBR 157 Software Administration Manual