Optoma ZU1100 Manual - Page 22

SETUP AND INSTALLATION 5. Zone D/E boresight adjustment. If zone D is in focus on the screen, please check the focal plane of zone E. ‡ If clear position is just on the screen then no need to adjust. ‡ If clear position is out of the screen (close to the projector), rotate screw 2 CCW and then screw 1 & 3 CW for half amount that 2 rotated. Then repeat until both D and E are clear. For example, turn 2 CCW in a circle, then turn 1 & 3 CW in half circle). ‡ If clear position is in the screen (away from the projector), rotate screw 2 CW and then screw 1 & 3 CCW for half amount that 2 rotated. Then repeat until both D and E are clear. 3 3 2 1 1 2 6. Zone H/I boresight adjustment. If zone H is in focus on the screen, please check the focal plane of zone I. ‡ If clear position is just on the screen then no need to adjust. ‡ If clear position is out of the screen (close to the projector), rotate screw 3 CCW and then screw 1 & 2 CW for half amount that 3 rotated. Then repeat until both H and I are clear. For example, turn 3 CCW in a circle, then turn 1 & 2 CW in half circle). ‡ If clear position is in the screen (away from the projector), rotate screw 3 CW and then screw 1 & 2 CCW for half amount that 3 rotated. Then repeat until both H and I are clear. 22 English 3 2 1 3 1 2