Optoma ZU1100 Manual - Page 52
D Tech, DLP-Link, 3D Sync, 3D-2D, 3D Sync Out, To Emitter, To Next Projector
View all Optoma ZU1100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
USING THE PROJECTOR 3D Tech Select a proper 3D technology according to how the 3D sync signal is processed. DLP-Link: Select DLP-Link when the 3D sync signal is generated by the DLP Link technology built into the projector. DLP Link works only with the glasses that are compatible with DLP 3D technology and the 3D function is enabled 3D Sync: Select 3D Sync when the 3D sync out signal is sent to an emitter or another projector through the 3D sync out port. 3D-2D Transform the 3D content to 2D images. 3D: Play the 3D content normally. L: Play the left images of the 3D content. R: Play the right images of the 3D content. 3D Sync Out Set up the transmission of the 3D sync output signal. To Emitter: Send the 3D sync signal to the emitter connected to the 3D sync out port. To Next Projector: Send the 3D sync signal to next projector when using multiple projectors. IR Control setup when using the 3D IR emitter Infrared devices interfere with each other if placed in the same sensing angle. If you want to use the 3D IR emitter and the IR remote function, do any of the following: Place the 3D IR emitter outside the IR remote control sensing angle as shown below: Horizontally or Vertically ± 30° 3D IR emitter direction NG 3D IR emitter direction OK 3D IR emitter direction NG Horizontally or Vertically ± 30° Based on the room layout, disable either the front or the top remote receiver in the OSD menu > Communication > Remote Setup > IR Function menu to avoid the 3D IR emitter interference, yet allowing to use the IR remote control function. 52 English