Panasonic AJHD1400 AJHD1400 User Guide - Page 14
Rear panel, AC IN inlet, DC IN socket, <Notes>, Fuse holder
View all Panasonic AJHD1400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Parts and their functions (continued) Rear panel HD/SDI IN OUT1 OUT2 SD/SDI DVCPRO /DV TC HD/SD REF IN VIDEO OUT IN 1 Y PB AUDIO OUT OUT PUSH CH1 PUSH CH2 PUSH PUSH L R MONITOR PR AUDIO IN CH1 2 (SUPER) CH2 AUDIO MON OUT ENCODER REMOTE L DC OUT 12V 250mA R R E FUSE 250V T2.5AH M O F1 R T AC IN SIGNAL DC IN GND AC IN inlet This is the AC power inlet. Connect the accessory power cable here. When both an AC power supply and DC power supply have been connected, the AC power supply takes priority. DC IN socket This is the input connector for the DC 12V supply voltage. Use an external DC power supply rated at DC 12 V/7 A (12 A peak or higher) When the voltage has dropped to around 10.6V, the unit's power is automatically turned off. (When "TYPE-A" or "TYPE-B" is not selected as the menu item No.180 BATTERY SEL setting) Even when the supply voltage is restored later, the power will not automatically come back on. The POWER switch must be set to OFF and then back to ON several seconds later. 1 2 3 4 Pin No. 1 2 3 4 Signal Ground - - +12 V External DC adapter If an external DC power supply is used, then check the ratings of the external DC power supply so that they are compatible with those of this unit. Check the pin arrangements of the DC output terminal of the external DC power supply and those of the DC IN socket of this unit so that their polarities are correctly arranged. If +12 V are supplied to the unit's GND terminal by mistake, this may cause fire or injury. If the polarities of the DC IN connectors of other devices are incorrect, and the other devices are connected to the unit by mistake, fire or personal injury may result. z If an external DC power supply is used, then make sure that the external DC power supply is first turned ON, then this unit is turned ON. Improper operation may result in a malfunction in the unit due to slow startup of the output voltage of the external DC power supply. z If input exceeds 18 V by mistake, the protection feature shuts down the power source at around 20 to 35 V. Change the voltage to the regular voltage, and the unit is available. An AC source cannot be connected to this terminal. DC OUT socket This is the DC 12V output socket. Power is supplied from here to the external remote controller (AJ-A95: optional accessory). The DC power cable is packed together with the AJA95. 2 3 1 4 Pin No. 1 2 3 4 Signal Ground - - +12 V Fuse holder This holds the AC 250 V/2.5 A fuse (time lag type). Use the fuse specified by Panasonic. 14