Panasonic AJHD1400 AJHD1400 User Guide - Page 23

PF (Programmable Function) Three setup menu items can be registered in the PF buttons, and these buttons can then be used to change the setup menu settings by a simple operating procedure. Performing operations using the PF buttons 1 Open the setup menu by pressing the Menu button, and move the cursor to the A00 MENU by tilting the joystick down and then to the right. 2 Move the cursor to the item with the PF number to be registered (A04 to A06) by tilting the joystick up and down. SETUP-MENU MENU NO.A04- A02 P.ON LOAD OFF ¢A04 PF1 ASSIGN 012 A05 PF2 ASSIGN 513 A06 PF3 ASSIGN --END 3 When the joystick is pressed, a list of items which can be set is displayed. z The following menu items cannot be saved. No. Menu item 05 ENCODER SEL 06 V LEVEL CTRL 12 SYS H (HD) 14 SYS SC (SD) 15 VO SYS SC (SD) 16 SD SYS SC (SD) 18 SCH CORS (SD) 19 SCH FINE (SD) 20 AV PHASE 25 SYSTEM FERQ 26 HD SYS H ADV 181 TYPE A NEAR 182 TYPE A END 183 TYPE B NEAR 184 TYPE B END No. Menu item 653 Y LEVEL (HD) 654 Pb LEVEL (HD) 655 Pr LEVEL (HD) 656 BK LEVEL (HD) 658 Y LEVEL (SD) 659 Pb LEVEL (SD) 660 Pr LEVEL (SD) 661 BK LEVEL (SD) 662 V LEVEL 663 C LEVEL HUE (AJ-HD1400P) 664 C PHASE (AJ-HD1400E) SETUP LVL (AJ-HD1400P) 665 BK LVL (AJ-HD1400E) SETUP-MENU MENU NO.A04A04 PF1 ASSIGN 012 ¢--- NO ASSIGN 001 LOCAL ENA 002 LOCAL TIMER 003 REMAIN SEL 008 CHARA H-POS 009 REMAIN SEL 010 CHARA V-POS 4 Press the joystick to select the item at the cursor position; the display will then return to the regular menu. 5 When the MENU button is pressed, a confirmation screen is displayed. Press the PLAY button to finish registering the item in the PF button. z As for the menu items registered in the PF button, when the menu is not displayed due to change of settings in menu No. 25 SYSTEM FREQ are changed, the registered contents in the interlocked PF button will be in the "not saved" state and cannot be displayed nor operated. Refer to "Menus which are displayed" (page 32). The settings for the PF buttons are retained but will be updated once save operations are executed again. Operation using the PF buttons 1 When the PF button is pressed, the registered items are displayed on the monitor screen which is output from the VIDEO MON connector. 2 Press the PF1, PF2 or PF3 button that corresponds to the item whose setting is to be changed. Each time the button is pressed, the setting is updated in sequence. PF1:SYS FORMAT 50M PF2:INT SG CB75 PF3 3 When the PF button is pressed again, the regular display is restored. If no operations are made, the display is also restored automatically after five seconds elapse. 23