Panasonic WJHD200 WJHD200 User Guide - Page 16
Connection with the Camera, ALARM/REMOTE Connection, System Camera Connection
View all Panasonic WJHD200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
I Connection with the Camera Site G System Camera Connection Connect the system cameras directly to the recorder. I Connection with the Monitors Connect the spot and multiscreen monitors. Disk Recorder WJ-HD200 SPOT OUT MULTI SCREEN OUT IN 8 7 6 OUT 8 7 6 G Data-multiplex Camera Connection Connect the combination cameras and the receiver via the multiplex unit with the recorder. Combination Cameras Pan/Tilt Table Receiver POWER ON OFF ALARM ALARM SUSPEND Data Multiplex Unit WJ-MP204 Data Multiplex Unit 4 3 2 1 SPOT OUT A DATA 4 3 2 1 O MULTI SCREEN OUT RS-23 16 POWER ON OFF Spot Monitor POWER ON OFF Multiscreen Monitor I ALARM/REMOTE Connection A 25-pin connector is used to accept and supply control signals. 13 1 25 ALARM/REMOTE 14 Pin # Designation 1 Alarm Reset In Pin # Designation 14 Time Adjust Out 2 Alarm In 1 15 Alarm In 5 3 Alarm In 2 16 Alarm In 6 4 Alarm Recovery Out *1 17 Alarm In 7 5 Alarm Recovery Out 2 18 Alarm In 8 6 Alarm Out 1 19 Signal GND 7 Alarm Out 2 *2 20 Signal GND 8 Disk End Out 21 Play Status Out 9 Warning Out 22 EXT REC MODE In 10 Alarm In 3 23 No Connection 11 Alarm In 4 24 Sequence In 12 REC Status Out 25 Sequence Out 13 Time Adjust In