Panasonic WJHD200 WJHD200 User Guide - Page 46

G External Reset The activated alarm event except video motion detection, is reset when the recorder receives an external reset signal from the connected device via the REMOTE/ALARM connector on the rear panel. The ALARM indicator changes from blinking to a steady light. G Pressing REC STOP Button Pressing the [REC STOP] button resets alarm status and recording when MONITOR MODE is set to OFF. When SPOT is set, only the [ALARM RESET] button will reset alarm status and recording. REC STOP I Alarm Log Recall & Search The ALARM RECALL window displays the alarm event log in chronological order with event numbers, dates, times, and the activation sources. A maximum of 2 000 events can be stored. ALARM RECALL YEAR03 NO. DATE TIME ALM 1543 OCT30 23:58:12 T1 1542 OCT30 23:52:54 V2 1541 OCT30 23:40:29 V3 1540 OCT30 23:39:50 T4 1539 OCT30 23:35:41 L2 1538 OCT30 23:30:22 L1 1537 OCT30 23:25:55 T2 1536 OCT30 23:21:09 T2 (TOTAL 1543EVENTS) TO SEARCH PUSH T&D KEY ALARM RECALL YEAR03 NO. DATE TIME ALM 0003 OCT20 23:52:54 V2 0002 OCT20 23:51:54 V2 0001 OCT20 23:50:54 V2 PUSH JOG→DATA CLEAR. I Suspending Alarm Input This function may be convenient during setup procedures. When enabled, any alarm input is ignored and the recorder performs as follows. • The alarm event will be stored in the alarm log. • The recorder enters alarm recording. • The alarm buzzer does not sound. • The SUSPEND indicator lights up. 1. Hold down the alarm [RESET] button and [LOCK] button simultaneously to enable the suspension function. The SUSPEND indicator lights up. ALARM TIMER SUSPEND REMOTE RESET LOCK 2. Do the same as above to reset the suspension function. The indicator turns off. (TOTAL 1543EVENTS) TO SEARCH PUSH T&D KEY T: Alarm terminal was activated. V: VMD was activated. P: Alarm event notification from the PC. Note: In some cases the log displayed in the ALARM RECALL list may apply to the previous alarm record that was overwritten after selecting CONTINUE for the DISK END MODE. This is because the alarm log is updated later than the image data. G To Browse through Log 1. Hold down the JogDial for 2 seconds. The monitor displays the ALARM RECALL list. 2. Rotate the JogDial to scroll up or down the page. Scrolling speed is selected in the menu setup. 3. Hold down the JogDial for 2 seconds to quit the ALARM RECALL list and go back to the previous window. G To Sort by Channel 1. Hold down the JogDial for 2 seconds to display the ALARM RECALL list. The log of all channels appears. 2. Press the desired channel [CAM SEL] button. The indicator on the button lights up, and only the log of the selected channel will be displayed. 3. Press another channel button to select a new channel. 46