Panasonic WJHD200 WJHD200 User Guide - Page 44
Alarm Control Function, Alarm Input
![]() |
View all Panasonic WJHD200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
• During the sequence, the LEDs of the [CAMERA SELECT] buttons light up corresponding to the selected cameras that send images to the monitor. Multiscreen monitor MULTISCREEN SELECT (4A) 12 1 2 34 G Built-in Motion Detector The recorder detects motion for each of the eight video inputs, based on certain changes in the video signal. G Built-in Video Loss Detector The recorder detects any disconnection of the video inputs. The images of the disconnected channel will not be recorded. Spot monitor 1 1 2 4. During the sequence, press the [SEQUENCE] button to pause. The LED in the [SEQUENCE] button blinks. 5. Press the [SEQUENCE] button to restart the sequence. The LED turns to a steady light. 6. Press any of the numeric buttons to quit the sequence and return to spot monitoring. Note: The Auto Skip function can be programmed in the menu setup to be applied to the sequence to skip any steps where no video signal is present. Alarm Control Function The recorder performs alarm functions to warn the system operators when an event has occurred. I Alarm Input There are three alarm inputs to the recorder that allow the recorder to output warnings. G Connected Alarm Sensors A maximum of eight sensors can be connected to the terminals on the rear panel. Sensors may be installed in such places as parking lots or reception desks where cars and visitors come and go. I Alarm Output The recorder performs the following actions when an alarm is input. G Front Panel Indicators When an alarm is received, the ALARM indicator blinks and the LED in the corresponding [CAMERA SELECT] button blinks. More LEDs will blink when more alarm inputs arise. The LED will stop blinking when the preset time has elapsed (Auto Reset), when the [RESET] button is pressed on the front panel (Manual Reset), when the external reset signal is received on the rear panel (External Reset), or when the video signal lost on any channel is restored (Video Loss). The ALARM indicator will change from blinking to a steady light when Auto Reset or External Reset is implemented. This steady light notifies the system operator that there have been alarm activations that have not yet been manually reset. ALARM SUSPEND RESET CAMERA SELECT 1 2 3 4 5 6 7 8 44
![](/manual_guide/products/panasonic-wjhd200-wjhd200-user-guide-d198673/44.png)