Panasonic WJHD200 WJHD200 User Guide - Page 59
Trigger Action Setup, Camera Recording Setup, Alarm Recording Mode Setup ALM REC MODE
![]() |
View all Panasonic WJHD200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
The status display will indicate "*→ PLAY" while playing back the images recorded with a rate different from the preset. • The suffix "xxx" following "SP-" is specified in REC MODE TABLE in the ADDENDUM attached to the manual. 1. Select a recording mode. Audio data will be recorded when a mode with hyphen A is selected. Available recording modes: SF, FQ, NQ, EX, SP, SFA, FQ-A, NQ-A, EX-A, and SP-A 2. When SP or SP-A is selected, specify a recording rate (REC RATE). Available recording rates: From 0.1 to 30 FPS 3. When SP or SP-A is selected, specify a recording quality (REC QUALITY). Available recording qualities: SUPER FINE, FINE, NORMAL, EXTENDED 8 Alarm Recording Mode Setup (ALM REC MODE) Recording of alarm events arising within the time zone specified by the program will start with the preset parameters. Refer to "PROG NO. SETUP" described above for operating procedures and available parameters, since they are very similar. I Trigger Action Setup (TRIGGER ACTION SETUP) 8 Mode (MODE) OFF: Disables alarm recording, logging, or warning. REC&ALARM: Enables all alarm recording, logging and warning. REC: Enables alarm recording and logging, but disables warning. Click the [SET] button when items have been set properly. 8 Pre-alarm Recording (PRE ALM REC) Available times (seconds): 0S, 1S, 2S, 3S, 4S, and 5S 8 Post-alarm Recording (POST ALM REC) Available times (seconds): 5, 10, 20, 30 Available times (minutes): 1, 1.5, 2, 3, 6 Manual: Recording continues until the [REC STOP] button is pressed, or the RESET IN signal is supplied to the rear panel. Continue: Recording continues while the alarm input is active, or at least for 10 seconds if the input turns inactive earlier. I Camera Recording Setup (REC CAMERA SETUP) 8 Dynamic Recording (DYNAMIC REC) ALM-MULTI: Alarm activated channels are recorded with priority over others. OFF: All channels are recorded with the same priority. Click CAMERA REC SETUP in the system setup window to open the menu. This menu is provided for the purpose of saving disk space. Each camera channel can be recorded only when an alarm operates, while it will not be recorded in non-alarm status. ALARM-ONLY: Records the camera channel only when the alarm operates. 59
![](/manual_guide/products/panasonic-wjhd200-wjhd200-user-guide-d198673/59.png)