Panasonic WJHD200 WJHD200 User Guide - Page 38

G Camera Number Setup (CAM NO. SETUP) (exclusive to PS •DATA) Camera numbers will be used in a PS•DATA chain when you select a camera to control it from a system controller. 1. Move the cursor to CAM NO. SETUPO with the [D] or [C] button, and press the JogDial. The CAM NO. SETUP menu opens. CAM NO.SETUP CAM-PORT 1 2 3 4 5 6 7 8 CAM NO. 001 002 003 004 005 006 007 008 2. Move the cursor to the desired line with the [D] or [C] button. 3. Select the number with the JogDial, and press the JogDial. The default number is the same as the CAM-PORT number. Assignable numbers: From 001 to 128, each number must be unique in the chain. 4. Press the [SETUP/ESC] button to go back to the SERIAL PORT SETUP. I Network Setup (NETWORK SETUP) NETWORK SETUP LINE SPEED AUTO HTTP PORT→ 00080 DHCP OFF IP ADDR →192.168.000.010 NETMASK →255.255.255.000 GATEWAY →192.168.000.001 Note: The system will restart after the menu setup window is closed when any parameter in this window has been changed. G Line Speed (LINE SPEED) 1. Move the cursor to LINE SPEED with the [D] or [C] button. 2. Select the parameter with the JogDial, and press the JogDial. The default is AUTO. AUTO: The speed is automatically selected. 100M_FULL: 100 mega byte, full duplex 100M_HALF: 100 mega byte, half duplex 10M_FULL: 10 mega byte, full duplex 100M_HALF: 10 mega byte, half duplex G HTTP Port (HTTP PORT) Set an HTTP port number. The default is 80. Available port numbers: From 00000 to 65535, except the "well-known port" numbers assigned by IANA (Internet Assigned Numbers Authority) G Dynamic Host Configuration Protocol (DHCP) Dynamic Host Configuration Protocol is enabled or disabled. The default is OFF. Note: When ON is selected, you cannot enter the IP address, netmask, or gateway. The host gives these parameters. The given parameters will be displayed after getting the IP address from the DHCP server. 38