Panasonic WJHD200 WJHD200 User Guide - Page 41
System Information, HDD Hour Meter HDD HOUR METER, HDD Capacity HDD CAPACITY, Default DEFAULT
![]() |
View all Panasonic WJHD200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
I System Information (SYSTEM INFORMATION) SYSTEM INFORMATION HDD1 HOUR METER 10000H HDD2 HOUR METER 10000H HDD CAPACITY DEFAULT→ 228.99G SET→ SYSTEM VERSION X.XX SYSTEM LOGO G HDD Hour Meter (HDD HOUR METER) The meter shows how many hours each hard disk has been operated in playback, recording and idle. The built-in HDD needs replacement when the hour meter reads around 30 000 H. G HDD Capacity (HDD CAPACITY) The total usable capacity of the built-in hard disk is indicated. G Default (DEFAULT) This enables the recorder to restore all setup data to the default values. 1. Press the JogDial to move the cursor to DEFAULT. 2. When the cursor is on SET→, press the JogDial again. 3. Select YES or NO with the JogDial, and press the JogDial. The default is NO. NO: Current setup data is retained. YES: Current setup data is reset to the default values. When all setup data are reset to the defaults, "SET DONE" is displayed for a few seconds and then changes to SET→. Note: The recorder will restart when the network setup has been changed and the menu is closed. G System Log (SYSTEM LOG) The system log is displayed on the monitor with event numbers, dates, times, and causes. SYSTEM LOG (1 OF 10) NO. DATE TIME CAU 99 FEB28.03 6:50:06 WR1 98 FEB28.03 5:23:51 HD1 97 FEB20.03 10:10:23 HD2 96 FEB15.03 23:50:42 RV1 95 FEB11.03 23:52:10 FLL 94 JAN31.03 19:43:32 TML 93 JAN30.03 19:50:14 LS1 92 JAN15.03 19:52:54 FL% 91 JAN10.03 10:40:22 TM4 90 JAN01.03 10:50:20 LS1 Abbreviation Cause TML Thermal error WR1 WR2 RV1 RV2 HD1 HD2 FL% FLL Writing error HDD automatically removed S.M.A.R.T detects an error on HDD. HDD XX% HDD FULL TM* ALM VM* VMD Description Temperature exceeds the operating range. Writing error on HDD Master HDD Slave HDD Master HDD Slave HDD Warning, HDD is nearing to the end. HDD is FULL. Terminal alarm event was logged, but no picture recorded. * = 1-8 VMD event was logged, but no picture recorded. * = 1-8 LS* LOSS Video input loss on channel # (*). * = 1-8 PC* POW ERR PC Power Error PC alarm was logged, but no picture recorded. * = 1-8 Power disconnection due to electricity failure/trouble has been detected. Errors other than shown above G System Version (SYSTEM VERSION) This line displays the version number of the installed system software. You will need the version number when updating the software. 41
![](/manual_guide/products/panasonic-wjhd200-wjhd200-user-guide-d198673/41.png)