Panasonic WJHD200 WJHD200 User Guide - Page 33

• Simultaneous playback will pause prior to a time space depending on the recording rate when the playback area on the disk nears the recording area. This is to avoid the access collision caused by the simultaneous recording and playback in an area on the disk. 0.1 FPS: 20 minutes maximum 1 FPS: 2 minutes maximum 7.5 FPS: 15 seconds maximum 15 FPS: 7 seconds maximum • Even if preset to 30 or 15 FPS, the actual recording rate may drop to 7.5 FPS at worst while busy multitasks such as playback, remote-access playback, remote-access live image, FTP access, multi-split display, or video motion detection are carried out simultaneously. The status display will indicate "*→PLAY" while playing back the images recorded with a rate different from the preset. G Alteration Detection Setup (ALTER DETECT) You can enable or disable the recorder to add alterationdetection signals in the JPEG data supplied to the network. The default is OFF. 1. Move the cursor to ALT DET. 2. Select ON or OFF with the JogDial and press the JogDial. ON: Detects alterations. OFF: Does not detect. Note: When set to ON, the data transmission rate on the network will slow down. G Disk End Mode Setup (DISK END MODE) The menu offers the following options at the point where the available recording space on the disk is used up: [STOP], [CONTINUE] [STOP] DISK START Restart REC DISK START DISK END Stop REC Waiting for a new entry DISK END [CONTINUE] [Default] DISK START DISK END Overwritten automatically DISK START DISK END SYSTEM SETUP (1 OF 2) PASSWORD LOCK OFF ALL→ ***** OPERATION→ ***** KEYLOCK BUZZ OFF SKIP ALM-RECALL 1PAGE SIMUL REC&PLAY ON ALTER DETECT OFF DISK END MODE CONTINUE DISK END BUZZ ON 1. Move the cursor to DISK END MODE with the [D] or [C] button. 2. Select the desired mode with the JogDial, and press the JogDial. The default is CONTINUE. STOP: Stops recording until a new mode other than STOP is selected. CONTINUE: Old data is automatically overwritten from the disk start. Note: Remaining capacity will be displayed on the monitor by turning the JogDial counter-clockwise in recording mode when STOP is selected. G Disk End Buzzer (DISK END BUZZ) The buzzer can be set up to beep at the point where the disk is full (remaining space 0 %). The setting is available only when STOP is set for DISK END MODE. 1. Move the cursor to DISK END BUZZ with the [D] or [C] button. 2. Rotate the JogDial to select the desired parameter. The default is ON. ON: Enables the buzzer beep at the disk end (remaining space 0 %). OFF: Disables the buzzer beep. G Play Priority Setup (PLAY PRIORITY) This setting places priority on a specific access point for playing back the image data when access collisions take place. 1. Move the cursor to PLAY PRIORITY. 2. Select an access point with the JogDial and press the JogDial. LOCAL: Places priority on front panel operations. NET PLAY: Places priority on network access. FTP GET: Places priority on access to the FTP. NONE: The latest operation has priority over others. 33