Pioneer DVR-520H-S Owner's Manual - Page 98

13 The Initial Setup menu Input Level (L1 / L2 / L3) • Default setting: 0dB Initial Setup Basic Tuner Video Out Audio In Audio Out Language Recording Playback External Audio Dual Mono Recording DV Input Input Level (L1) Input Level (L2) Input Level (L3) +6dB +3dB 0dB - 3dB - 6dB You can adjust the gain of the audio from each external input individually, from -6dB to +6dB in steps of 3 dB to optimize the recorded audio level. Audio Out settings Digital Out • Default setting: On Initial Setup Basic Digital Out On Tuner Dolby Digital Out Off Video Out DTS Out Audio In 96kHz PCM Out Audio Out MPEG Out Language Recording Playback If at any time you need to switch off the digital audio output, set this to Off, otherwise leave it On. Note • When set to Off, all the other Audio Out settings are grayed out and can't be set. Dolby Digital Out You only need to make this setting if you connected this recorder to an AV amp/receiver (or other component) using the digital output. • Default setting: Dolby Digital Initial Setup Basic Tuner Video Out Audio In Audio Out Language Recording Playback Digital Out Dolby Digital Out DTS Out 96kHz PCM Out MPEG Out Dolby Digital Dolby Digital PCM If your AV amp/receiver (or other connected component) is Dolby Digital compatible, set to Dolby Digital, otherwise set to Dolby Digital PCM. Check the manual that came with the connected component if you're unsure whether it is Dolby Digital compatible. DTS Out You only need to make this setting if you connected this recorder to an AV amp/receiver (or other component) using the digital output. • Default setting: On Initial Setup Basic Digital Out On Tuner Dolby Digital Out Off Video Out DTS Out Audio In 96kHz PCM Out Audio Out MPEG Out Language Recording Playback If your AV amp/receiver (or other connected component) has a built-in DTS decoder, set to On, otherwise set to Off. Check the manual that came with the connected component if you're unsure whether it is DTS compatible. Important • If you set to On with a non-DTS compatible amp/ receiver, noise will be output when you play a DTS disc. • When set to On, there is no analog audio output when playing a DTS DVD-Video disc. • When playing a DTS audio CD (even when DTS Out is Off), noise is output from the analog outputs. Do not play this through your amplifier and speakers. • When playing a DTS audio CD, make sure that Stereo is selected using the AUDIO button. See Switching audio channels on page 43. 96kHz PCM Out You only need to make this setting if you connected this recorder to an AV amp/receiver (or other component) using the digital output. • Default setting: 96kHz 48kHz Initial Setup Basic Tuner Video Out Audio In Audio Out Language Recording Playback Digital Out Dolby Digital Out DTS Out 96kHz PCM Out MPEG Out 96kHz 48kHz 96kHz 98 En