Pioneer VSX-45TX Owner's Manual - Page 101

For explanation purposes the illustrations use ALL CH ADJUST. 1 Acoustic Cal EQ [ CUSTOM1 ADJUST ] [ CUSTOM2 ADJUST ] [ DATA COPY ] [ DATA CHECK ] [Exit ] 2 Acoustic Cal EQ [ALL CH ADJUST ] [ FRONT ALIGN ] [Exit ] 3 ALL CH ADJUST [ Front L EQ] [ Center EQ] [ Front R EQ] [ Surround R EQ ] [ SurrBack R EQ ] [ SurrBack L EQ ] [ Surround L EQ ] [Exit ] 4 Center EQ 63Hz 125Hz 250Hz 4 kHz 11.3 kHz TRIM [Exit] [ +1. 5dB] [ +2. 5dB] [ -4. 0dB] [ -5. 5dB] [ +0. 5dB] [ +0. 0dB] 5 Center EQ 63Hz 125Hz 250Hz 4 kHz 11.3 kHz TRIM [Exit] [ +2. 0dB] [ +2. 5dB] [ -4. 0dB] [ -5. 5dB] [ +0. 5dB] [ +0. 0dB] Fine Tuning Your System This explanation is for CUSTOM 1 or CUSTOM 2. 1 The four possibilities should be on the OSD. Use the 5∞ buttons to select CUSTOM 1 or CUSTOM 2. Press ENTER. 2 Use the 5∞ buttons to select ALL CH ADJUST or FRONT ALIGN and press ENTER. The test tones will sound. WARNING: the test tones are very loud!! Make sure there are no infants or small children in the room and that no one who will be scared, upset or damaged by loud noise is present. You yourself may want to wear earplugs. Here the terms ALL CH ADJUST and FRONT ALIGN represent two types of equalizer methods that emphasize different characteristics of the sound. ALL CH ADJUST: In this method all the speakers (except for the subwoofer) are independent. The settings that were input when you did the AUTO SURROUND SETUP (see pages 13-15) will be present but you can adjust each speaker individually to suit your taste. The test tones for each channel will sound individually. FRONT ALIGN: In this method all speakers (except for the subwoofer) are set in accordance with the settings of the FRONT speakers. The settings that were input when you did the AUTO SURROUND SETUP (see pages 13-15) will be present but you can adjust each speaker individually to suit your taste. This setting allows the listener to enjoy a sound balance defined by the front speakers. The front left speaker will serve as the reference tone. The front left tone and the target speaker (the one you are trying to adjust) will sound in turns, so you can judge which needs to be louder. 3 Use the 5∞ buttons to select the channel that you want to adjust. Press ENTER. For FRONT ALIGN you won't be able to adjust the FRONT speakers. 4 Use the 5∞ buttons to select the frequency you want to adjust. Press ENTER. For the speakers you set to SMALL (see page 40) you won't be able to adjust the 63 Hz setting. 5 Use the 5∞ buttons to adjust the frequency. When you have it at the level you want press ENTER. Set the frequencies within the -6 dB to +6 dB range in steps of 0.5 dB. If OVER appears in the display you have set the levels too high. Reduce them until OVER disappears. 6 The cursor automatically goes to the next frequency. Press ENTER and repeat 101 steps 4 & 5 to adjust all the frequencies. EXPERT