Pioneer VSX-45TX Owner's Manual - Page 91

Fine Tuning Your System Assigning the Digital Inputs If you did not hook up your digital equipment in accordance with the default settings for the digital inputs (see pages 17,19 & 22-23) you need to complete the procedure below. You have to do this in order to tell the receiver what digital equipment is hooked up to which terminal so the buttons on the remote correspond to what you have hooked up. 2 VCR2 VIDEO CD MULTI OPERATION CD-R/ TAPE1 MD/ TAPE2 TUNER RECEIVER DIMMER LOUDNESS 1 2 TONE EFFECT/CH SEL 3 4 SIGNAL SEL 5 VIDEO SEL 9 DNR BASS/TREBLE + 6 7 8 HI-BIT +10 - DISC 0 ENTER SYSTEM SETUP DIRECT ACCESS SEARCH MODE GUIDE MENU TOP MENU TUNER EDIT ENTER TRACK EXIT AUDIO RETURN MPX DTV ON/OFF DISP MODE ¶ 8 SUB TITLE 1 3-8 (If you are continuing from page 89 you can skip the first two steps.) 1 Turn on the receiver and your TV, press RECEIVER on the remote control. 2 Press the SYSTEM SETUP button. 3-8 2 STANDBY/ON MOVIE MUSIC ENTER MULTI JOG STANDBY MULTI JOG CONTROL SET UP RETURN SIGNAL HI-BIT SELECT HI-SAMPLING SB CH MODE BAND PHONES SPEAKERS TONE TONE CONTROL BASS/TREBLE 3 Looking at the on-screen display on your TV, use the 5∞ buttons to select INPUT ASSIGN. Press the ENTER button. 4 DIGITAL-IN SELECT should be selected, if not use the 5∞ buttons to select it. Press the ENTER button. 3 System Setup [ 1. Surround Setup ] [ 2. THX CINEMA Setup ] [ 3. Input Assign ] [ 4. Function Rename ] [ 5. PHONO/LINE Setup ] [ 6. Multi Room ] [ 7. 12V Trigger ] [ Exit ] 4 3.Input Assign [ Digital-In Select ] [ Component-In Select ] 5 Use the 5∞ buttons to move through the different digital inputs and press the ENTER button. 6 Use the 5∞ buttons select the component that you hooked up to that digital in. Press the ENTER button. If you're not sure which component is connected to which digital in, look on the back of the receiver and check the cables you connected. [Exit] 5 Digital-In Select Digital-1 Digital-2 Digital-3 Digital-4 [ TV/SAT ] [ DVD/LD ] [ OFF ] [ CD ] [Exit] memo • The possible digital inputs that can be assigned are: DVD/LD, TV/SAT, VCR1, VCR2, CD, CD-R, MD. 7 When you're finished use the 5∞ buttons to select EXIT and press ENTER. This exits the DIGITAL-IN SELECT mode. 8 Use the 5∞ buttons to select EXIT and press ENTER. Then, use the 5∞ buttons to select EXIT and press ENTER again. This exits the SYSTEM SETUP mode and returns to normal operation. • If you assign a digital input to a certain function (for example DVD/LD) then any digital inputs pre- viously assigned to that function will automati- cally be set to OFF. This is because one func- tion cannot be assigned to two different places. 91 EXPERT