Pioneer VSX-45TX Owner's Manual - Page 34

Displays & Controls Back Panel All the terminals on the back panel are explained and/or referenced here. 12 3 4 5 6 7 ASSIGNABLE PCM/ 2DIGITAL / DTS/MPEG FM UNBAL 75Ω OUT1 IN OUT OUT2 CONTROL R L IN 1 PLAY (TV/ SAT) IN IN 2 CD-R/ (CD-R/ TAPE1 TAPE1) OUT REC IN 3 (DVD/ LD) IN 4 (CD) PLAY IN MD/ TAPE2 OUT REC CD IN PHONO/ LINE USB IN AUDIO R L DIGITAL AUDIO AM LOOP ANTENNA MULTI-ROOM & SOURCE MULTI-ROOM & SOURCE PRE OUT MONITOR OUT CENTER SUB WOOFER R OUT L MONITOR OUT FRONT R L AUDIO IN VCR1/ DVR OUT IN VCR2 OUT TV/ SAT IN R SURROUND R SURROUND BACK R FRONT R SURROUND R SUB WOOFER L L (Single) L L L CEN- TER DVD/ LD IN SURROUND BACK R L VIDEO S VIDEO VIDEO MULTI CH IN 13 14 15 16 1 DIGITAL IN terminals (see page 22) Use these terminals to input the signal from a DVD, CD player or any other kind of digital player. To be able to play Dolby Digital and other surround soundtracks you need to make digital connections. To do this use the digital terminals here. If you don't connect as per the default settings (see page 23) you need to complete "Assigning the Digital Inputs" (see page 91). 2 DIGITAL OUT terminals (see page 22) Use these terminals to output a digital signal to a DVD-R, CD-R, MD recorder or any other kind of digital recorder. 3 CONTROL IN/OUT terminal (see page 79) You can use this jack to hook up other PIONEER equipment, that has a CONTROL terminal, so that you can control them all by pointing the remote control(s) at one remote sensor. 4 Radio antenna terminals (see page 24) Hook up antennas for the radio tuner built into the receiver here. 34 5 MULTI ROOM & SOURCE OUT terminals (see pages 74-79). These terminals output the audio & video signal to a sub-system in a secondary room. Note that the MONITOR OUT here is different than the MONITOR OUT for the main system. These are analog jacks. 6 MONITOR OUT terminals (connect a TV or monitor here, see page 16) Use this terminal to output the video signal to your TV, video projector or monitor in your main room. Be careful not to confuse this jack with the MULTI ROOM & SOURCE MONITOR OUT. 7 PRE OUT analog terminals (connect an amplifier here, see page 73) Use these terminals to output the audio signal from this amplifier to a different amplifier if that's how you choose to set up your system. 8 COMPONENT VIDEO MONITOR OUT terminals Use these terminals to output the video signal from the COMPONENT VIDEO IN terminals to your TV. See #17 for more information. 9 12V TRIGGER terminal (see pages 95) Use this terminal to output a signal that can automatically turn on another component. DC OUT12V/100mA is the maximum power.