Pioneer VSX-45TX Owner's Manual - Page 104
OFF, MID or MAX. Press ENTER.
View all Pioneer VSX-45TX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Fine Tuning Your System DYNAMIC RANGE CONTROL This feature makes it possible to enjoy full surround sound effects on Dolby Digital and DTS sources even at low volumes. It does this by compressing the dynamic range. Dynamic range is the difference between the loudest and the softest sounds in any given signal. Compressing the range plays sounds so the quieter ones are audible and the louder ones don't get distorted or become overpowering. This feature only applies to Dolby Digital and DTS sources but the MIDNIGHT mode (explained on page 51) accomplishes the same end for a variety of sources. If continuing from BASS PEAK LEVEL, DYNAMIC RANGE CONTROL should be selected. DIMMER LOUDNESS 1 2 TONE EFFECT/CH SEL 3 4 SIGNAL SEL 5 VIDEO SEL 9 DNR BASS/TREBLE + 6 7 8 HI-BIT +10 - DISC 0 ENTER SYSTEM SETUP DIRECT ACCESS SEARCH MODE GUIDE MENU TOP MENU TUNER EDIT ENTER TRACK EXIT AUDIO RETURN MPX DTV ON/OFF DISP MODE ¶ 8 SUB TITLE 1-6 1-6 STANDBY/ON MOVIE MUSIC ENTER MULTI JOG STANDBY MULTI JOG CONTROL SET UP RETURN SIGNAL HI-BIT SELECT HI-SAMPLING SB CH MODE BAND PHONES SPEAKERS TONE TONE CONTROL BASS/TREBLE 1 Expert [Crossover Network ] [Fine Channel Level ] [Fine Channel Delay ] [Acoustic Cal EQ ] [Bass Peak Level ] [D-Range Control ] [Exit ] Follow steps 1-5 on page 96, if necessary, to get to the starting point mentioned here. 1 D-RANGE CONTROL should be selected, if it isn't use the 5∞ buttons to select and press ENTER. 2 Use the 5∞ buttons to choose either OFF, MID or MAX. Press ENTER. Dynamic Range Control is set. OFF: No Dynamic Range Control. MID: A moderate amount of Dynamic Range Control is applied. MAX: The most Dynamic Range Control available is applied. 3 EXIT should be selected (if it isn't use the 5∞ buttons to select it), press ENTER. If you want to change a setting before proceeding Start over from step 1. 4 You are now finished with EXPERT SETUP, EXIT should be selected (if it isn't use the 5∞ buttons to select it), press ENTER. 2 Dynamic Range Control Select Mode dts [OFF] [MID] [MAX] [Exit ] 5 EXIT in SURROUND SETUP menu should be selected (if it isn't use the 5∞ buttons to select it), press ENTER. 3 Dynamic Range Control Select Mode dts [OFF] [MID] [MAX] [Exit ] 6 Use the 5∞ buttons to select EXIT in the SYSTEM SETUP menu, press ENTER. The receiver returns to normal operation. memo The default is OFF. 104