Sanyo PDG-DHT8000L RS232C Expand - Page 27
PC Control Command, 5.1 CF_FSYNC Command, 5.2 CF_TDOTS Command, 5.3 CF_H-POS Command
![]() |
View all Sanyo PDG-DHT8000L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
PDG-DHT8000L Expand Serial Command Functional Specifications 8.5 PC Control Command 8.5.1 CF_FSYNC Command Command "CF_FSYNC_%1" [CR] "0000-0031 Directly specify setting value of Fine Sync %1 "UP Increment setting value of Fine Sync by 1 "DN Decrement setting value of Fine Sync by 1 Details Set value of Fine Sync in PC signal (Available only in the normal Power ON status) The value set by this command is not stored in the projector's memory. Therefore, when the power is turned to ALL OFF status, the value returns to the original setting. (It is stored in Suspend mode.) Acceptable Response Unacceptable "000" [CR] "101" [CR] --- When input is Video signal --- When input is no signal 8.5.2 CF_TDOTS Command Command "CF_TDOTS_%1" [CR] "mmmm - nnnn Directly specify setting value of Total Dots "mmmm" indicates minimum value, which is current (Display Area H + Position H) value %1 "nnnn" indicates maximum value, that dot clock does not exceed more than 160MHz. "UP Increment setting value of Total Dots by 1 "DN Decrement setting value of Total Dots by 1 Details Set value of Total Dots in PC signal (Available only in the normal Power ON status). The value set by this command is not stored in the projector's memory. Therefore, when the power is turned to ALL OFF status, the value returns to the original setting. (It is stored in Suspend mode.) Acceptable Response Unacceptable "000" [CR] "101" [CR] --- When input is Video signal --- When input is no signal 8.5.3 CF_H-POS Command Command "CF_H-POS_%1" [CR] "0000-nnnn" -------- Directly specify setting value of Horizontal Position %1 "nnnn" indicates maximum value, which is current value of (Total Dots - Display Area H) "UP Increment setting value of Horizontal Position by 1 "DN Decrement setting value of Horizontal Position by 1 Details Set value of Horizontal Position in PC signal (Available only in the normal Power ON status) The value set by this command is not stored in the projector's memory. Therefore, when the power is turned to ALL OFF status, the value returns to the original setting. (It is stored in Suspend mode.) Response Acceptable Unacceptable "000" [CR] "101" [CR] --- When input is Video signal --- When input is no signal 27/101
![](/manual_guide/products/sanyo-pdgdht8000l-rs232c-expand-3796ec4/27.png)