Sanyo PDG-DHT8000L RS232C Expand - Page 96
CR_P-TIMER Command, 11.6 CR_TEMPWARN Command
View all Sanyo PDG-DHT8000L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
PDG-DHT8000L Expand Serial Command Functional Specifications 9.11.5 CR_P-TIMER Command Command "CR_P-TIMER" [CR] Details Get Presentation Timer operating status Acceptable "000_%1" [CR] "ON Presentation Timer is ongoing. Response %1 "STOP Presentation Timer is paused. "OFF Presentation Timer is not active. Unacceptable "?" [CR] 9.11.6 CR_TEMPWARN Command Command "CR_TEMPWARN" [CR] Details Get the information about the temperature inside the projector (close to the abnormal or in the abnormal status/in the safe temperature level/abnormal status is not detected). It is possible to get the information about more than one sensor all at once if it is applicable. Acceptable "000_%1" [CR] "*_*" Sensor 1 data comes first, and then one space, after that sensor 2 data is followed. Each data is as below: "W"--- in or close to the abnormal temp. (Warning Temp.) Response %1 "S"--- in the safe level of temperature (Safe Temp.). "N"--- the given sensor does not detect abnormal temp. e.g. "S_W" [CR] indicates that the temperature detected at Sensor 1 is in the safe level while Sensor 2 in the abnormal temperature. Unacceptable "?" [CR] 96/101