Sharp 3800M Operation Manual - Page 140
Transport
View all Sharp 3800M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
Transport When moving the machine, follow the procedure below. When moving this machine, be sure to remove the TD cartridge.This prevents toner from spilling inside the machine during shipment. 1 Turn the power switch off and disconnect the power cord. 2 Remove the printer interface cable. 3 Push gently on both sides of the front cover to open the cover. 4 Gently pull theTD cartridge out.See page 29,TD CARTRIDGE REPLACEMENT. 5 Remove the copy paper from the paper tray.To remove the paper, see page 35, Misfeed in the paper tray. 6 Remove the paper tray from the machine. 7 Gently push the paper output tray back into the machine until it stops. 8 Attach to the left side of the machine the screw that has been saved. See page 3, SET UP. 14 When shipping the machine, the screw must be reinstalled to prevent shipping damage. This screw will secure the scanning head. If the power has been turned off while an original was being scanned, the scanning head is not at the left end position. In this case, turn on the machine and then turn it off after checking the head is at the left end position. 9 Close the front cover. 10 Attach the packing materials and tape which were removed during installation of the machine See page 3, SET UP. 11 Pack the machine into the carton. 130 SPECIFICATIONS SUK 14 SPECIFICATIONS LEO.p65 130 30/03/00, 17:27