Sharp MX-M350N Fax Guide - Page 80

PROGRAMMING, EDITING, AND DELETING F-CODE MEMORY BOXES The procedure for programming a memory box for F-code transmission is explained here. There are three types of F-code memory boxes: F-code polling memory (page 4-4), F-code confidential transmission (page 4-6), and F-code relay broadcast (page 4-8). Memory boxes are programmed, edited, and deleted as follows. PROGRAMMING AN F-CODE MEMORY BOX A box name, sub-address/passcode, and function must be programmed in a memory box. NOTES When programming a new memory box, a sub-address that is being used for another box cannot be used. The passcode, however, can be the same as a passcode used in another box. A passcode can be omitted. Up to 100 F-code memory boxes can be programmed. If 100 F-code memory boxes have already been programmed, a warning message will appear and you will not be able to program a new box. First delete an unused F-code memory box (page 6-13) and then program the new box. 1 Press the [CUSTOM SETTINGS] key and then touch the [ADDRESS CONTROL] key (refer to steps 1 and 2 on page 6-2). 2 Touch the [F-CODE MEMORY BOX] key. O 5 Touch the [SUB ADDRESS] key. F-CODE MEMORY BOX / POLLING MEMORY No.001 BOX NAME FAX INFORMATION The sub-address/ passcode entry screen appears. SUB ADDRESS POLLING TIMES F-CODE MEMORY BOX 3 Touch one of the memory box keys ([POLLING MEMORY], [CONFIDENTIAL], or [RELAY BROADCAST] ) on the store (upper) line. CUSTOM SETTINGS F-CODE MEMORY BOX OK STORE POLLING MEMORY CONFIDENTIAL RELAY BROADCAST AMEND/DELETE POLLING MEMORY CONFIDENTIAL RELAY BROADCAST ([POLLING MEMORY] is touched in the example here.) The F-code memory box programming screen appears. 4 Touch the [BOX NAME] key. F-CODE MEMORY BOX / POLLING MEMORY The "No." that automatically No.001 appears is the lowest BOX NAME number from 001 to 100 that has not yet been SUB ADRESS programmed. When the POLLING TIMES [BOX NAME] key is touched, the letter-entry screen appears. Enter up to 18 characters for the name. For information on entering characters, see chapter 7 of the "Operation manual (for general information and copier operation)". 6-10 Downloaded From ManualsPrinter.com Manuals 6 Use the numeric keys (0 through 9) to enter a sub-address (max. 20 digits). F-CODE MEMORY BOX / POLLING MEMORY NEXT No.001 SUB ADDRESS / PASS CODE CANCEL ENTER THE SUB ADDRESS / PASS CODE VIA THE 10-KEY PAD,THEN PRESS [OK]. EXIT OK 214341434 PASS CODE The characters " " and "#" cannot be used in a sub-address. If you enter an incorrect digit, press the [C] key and re-enter the correct digit. If you do not wish to enter a passcode, proceed to step 9. 7 To set a passcode, touch the [PASS CODE] key. CANCEL OK -KEY PAD,THEN PRESS [OK]. PASS CODE A slash (/) appears after the sub-address. If you enter an incorrect digit, press the [C] key and re-enter the correct digit