Sony SRG300SE User Manual (SRG-300SE User's Guide) - Page 58

Others Message List The following messages and indications may appear on this camera. Perform the following as necessary. POWER indicator lit NETWORK indicator Lights green Unlit Camera status Operating normally Not connected to the network POWER indicator flashing NETWORK indicator Camera status Repeats green t yellow t orange Software version is being upgraded Repeats green t yellow t unlit t green t orange t Initializing unlit POWER indicator unlit NETWORK indicator Unlit Lights green Lights orange Camera status No power supplied Starting Preparing to initialize Screen display It is displayed on the external monitor connected to the SDI output when the DISPLAY INFO setting is set to ON in the "SYSTEM Menu" on page 56 and the following operations are performed from the remote controller. Message PRESET n OK ("n" is a preset position number between 1 and 16.) RECALL n OK ("n" is a preset position number between 1 and 16.) RESET n OK ("n" is a reset position number between 1 and 16.) ONE PUSH WB:OP ONE PUSH WB:OK ONE PUSH WB:NG Meaning and solution This message appears for about 3 seconds when you store camera settings to POSITION 1 to 16. This message appears for about 3 seconds when you read the camera settings stored in POSITION 1 to 16. This message appears for about 3 seconds when you reset camera settings stored in POSITION 1 to 16. During the white balance adjustment in the ONE PUSH white balance mode, this message flashes on the screen. When the white balance adjustment has been done correctly in the ONE PUSH white balance mode, this message appears on the screen. When the white balance adjustment has failed in the ONE PUSH white balance mode, this message flashes on the screen. Check the exposure condition and the subject and execute the one-push white balance adjustment. Others 58 Message List