TP-Link 13dBi CPE510 V1 UG - Page 41
WAN, AP router, AP client router WISP Client, Static
View all TP-Link 13dBi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Chapter 5 Network Tab WAN NOTE: WAN submenu is only available on AP router mode and AP client router (WISP Client) mode. There are five WAN connection types: Static, Dynamic, PPPoE, L2TP, and PPTP. Select the suitable one to configure the IP parameters of the WAN on the screen below. If you are not sure of the connection type to use, please consult your ISP. Static This connection type uses a permanent, fixed (static) IP address that your ISP assigned. In this type, you should fill in the IP address, Netmask, Gateway IP, and DNS IP address manually, which are specified by your ISP. IP Address Netmask Gateway IP Primary DNS Enter the IP address provided by your ISP. Enter the Netmask provided by your ISP. Normally use 255.255.255.0 as the netmask. Enter the gateway IP address provided by your ISP. Enter the DNS IP address provided by your ISP. - 38 -