TP-Link T1700X-16TS T1700X-16TSUN V1 CLI Reference Guide - Page 143
IPv6 Address Configuration Commands
View all TP-Link T1700X-16TS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
Chapter 19 IPv6 Address Configuration Commands The IPv6 address configuration commands are provided in the Interface Configuration Mode, which includes the routed port, the LAG and the VLAN interface. Enter the configuration mode of these Layer 3 interfaces and configure their IPv6 parameters. 19.1 ipv6 enable Description This command is used to enable the IPv6 function on the speicified Layer 3 interface. IPv6 function should be enabled before the IPv6 address configuration management. By default it is enabled on VLAN interface 1. IPv6 function can only be enabled on one Layer 3 interface at a time. If the IPv6 function is disabled, the corresponding IPv6 netstack and IPv6-based modules will be invalid, for example SSHv6, SSLv6, TFTPv6 etc. To disable the IPv6 function, please use no ipv6 enable command. Syntax ipv6 enable no ipv6 enable Command Mode Interface Configuration Mode Example Enable the IPv6 function on the VLAN interface 1: T1700X-16TS(config)# interface vlan 1 T1700X-16TS(config-if)# ipv6 enable 19.2 ipv6 address autoconfig Description This command is used to enable the automatic configuration of the ipv6 link-local address. The switch has only one ipv6 link-local address, which can be configured automatically or manually. The general ipv6 link-local address has the prefix as fe80::/10. IPv6 routers cannot forward packets that have link-local source or destination addresses to other links. The autuconfigured ipv6 link-local address is in EUI-64 format. To verify the uniqueness of the link-local address, the manually configured ipv6 link-local address will be deleted when the autoconfigured ipv6 link-local address takes effect. 129