TRENDnet TV-IP743SIC User's Guide - Page 55

Federal Communica°on Commission Interference Statement, FCC Interference Statement

Page 55 highlights

TV-IP743SIC User's Guide Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Interference Statement IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The availability of some specific channels and/or operational frequency bands are country dependent and are firmware programmed at the factory to match the intended destination. The firmware setting is not accessible by the end user. © Copyright 2014 TRENDnet. All rights reserved. 52

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59

TV-IP743SIC User’s Guide
FCC Interference Statement
© Copyright 2014 TRENDnet. All rights reserved.
52
Federal Communica°on Commission Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules�
These limits are
designed to provide reasonable protec±on against harmful interference in
a residen±al installa±on. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instruc±ons, may cause harmful interference to radio communica±ons.
However, there is no guarantee that interference will not occur in a par±cular
installa±on.
If this equipment does cause harmful interference to radio or
television recep±on, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna�
Increase the separa±on between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected�
Consult the dealer or an experienced radio/TV technician for help�
FCC Cau°on:
Any changes or modifica±ons not expressly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment�
This device complies with Part 15 of the FCC Rules. Opera±on is subject to the
following two condi±ons: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired opera±on.
IMPORTANT NOTE:
FCC Radia°on Exposure Statement:
This equipment complies with FCC radia±on exposure limits set forth for an
uncontrolled environment� This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body�
This transmi²er must not be co-located or opera±ng in conjunc±on with any
other antenna or transmi²er.
The availability of some specific channels and/or opera±onal frequency bands
are country dependent and are firmware programmed at the factory to match
the intended des±na±on. The firmware se°ng is not accessible by the end
user�