2014 Ford F150 SuperCrew Cab Owner Manual Printing 1 - Page 126
2014 Ford F150 SuperCrew Cab Manual
Page 126 highlights
Universal Garage Door Opener (If Equipped) To program another rolling code device, repeat Steps 1 through 6, substituting a different function button in Step 5. Fixed Code Programming Note: It may be helpful to have another person assist you in programming the transmitter. To program units with fixed code DIP switches, you will need the garage door hand-held transmitter, paper and a pen or pencil. 1. Switch the ignition on. 2. Open the battery cover and note all the switch settings from left to right. E164776 Note: You must complete the following step within 2.5 minutes. 4. Enter the corresponding DIP switch settings from left to right into the system by pressing and releasing the buttons corresponding to the settings you noted. 5. Simultaneously press and release all three function buttons. The LED lamps will illuminate. 6. Press and hold the function button you would like to use to control the garage door. Note: You may need to hold the button from 5-55 seconds before observing movement of the garage door. 7. When the garage door moves, release the button within one second. After you release the button, the LED lamp will flash slowly. 8. The LED lamp will begin to flash rapidly until programming is complete. If your garage door does not operate, repeat the previous steps. Otherwise, call the toll-free help line at 1-866-572-2728. The LED lamp above the selected button will illuminate to confirm that the system is responding to the button command. Erasing the Function Button Codes Note: You cannot erase individual buttons. 1. Press and hold the outer two function buttons simultaneously for approximately 20 seconds until the LED lamps above the buttons flash rapidly E164778 • • • When the switch is in the up, on, or + position, mark down "left button". When the switch is in the middle, neutral, or 0 position, mark down "middle button". When the switch is in the down, off, or - position, mark down "right button". 3. Press all three function buttons simultaneously for a few seconds and then release. The LED lamps will flash slowly. E164776 124 F150 (TF6)