2014 Ford F150 SuperCrew Cab Owner Manual Printing 1 - Page 60

Locks 3. Enter your personal 5-digit code. You must enter each number within five seconds of each other. 4. Press 1·2 on the keypad to save personal code 1. The doors will lock then unlock to confirm that programming was successful. To program additional personal entry codes, repeat Steps 1-3, then for Step 4: • press 3·4 to save personal code 2 • press 5·6, 7·8 or 9·0 to save personal code 3. You may also program a personal entry code through the MyFord Touch system. Tips: • Do not set a code that uses five of the same number. • Do not use five numbers in sequential order. • The factory-set code will work even if you have set your own personal code. Recalling Memory Positions (If Equipped) The programmed entry codes will recall driver memory positions as follows: • • Entry code 1 will recall driver 1 memory positions. Entry code 2 will recall driver 2 memory positions. All personal codes will erase and only the factory-set 5-digit code will work. Anti-Scan Feature The keypad will go into an anti-scan mode if you enter the wrong code seven times (35 consecutive button presses). This mode disables the keypad for one minute and the keypad lamp will flash. The anti-scan feature will turn off after: • one minute of keypad inactivity • pressing the unlock button on the remote control • switching the ignition on. Unlocking and Locking the Doors To Unlock the Driver Door Enter the factory-set 5-digit code or your personal code. You must press each number within five seconds of each other. The interior lamps will illuminate. Note: All doors will unlock if you disable the two-stage unlocking mode. See Locking and Unlocking (page 56). To Unlock All Doors Enter the factory-set code or your personal code, then press 3·4 within five seconds. To Lock All Doors Press and hold 7·8 and 9·0 at the same time (with the driver door closed). You do not need to enter the keypad code first. Displaying the Factory Set Code Note: You will need to have two programmed passive anti-theft keys for this procedure. To display the factory-set code in the information display: 1. Insert a key into the ignition and switch the ignition on for a few seconds. Note: Personal entry codes 3, 4 and 5 will not recall memory positions. Erasing a Personal Code 1. Enter the factory-set 5-digit code. 2. Press and release 1·2 on the keypad within five seconds. 3. Press and hold 1·2 for two seconds. You must do this within five seconds of completing Step 2. 58 F150 (TF6)