2014 Ford F150 SuperCrew Cab Owner Manual Printing 1 - Page 130

Universal Garage Door Opener (If Equipped) 4. Press and hold both the programmed Genie button on the hand-held transmitter and the button you want to program. The indicator light on the visor will flash rapidly when the programming is successful. Note: The Genie transmitter will transmit for up to 30 seconds. If HomeLink does not program within 30 seconds you will need to press the Genie transmitter again. If the Genie transmitter indicator light displays green and red, release the button until the indicator light turns off before pressing the button again. Once you have programmed HomeLink successfully, you must change the Genie transmitter out of program mode. To do this: 1. Press and hold the previously programmed Genie button on the hand-held transmitter for 10 seconds. The indicator light will change from red to red and green. 2. Press the same button twice to confirm the change. If done correctly the indicator light will turn green. Programming HomeLink to the Genie Intellicode Garage Door Opener Motor Note: You may need a ladder to access the garage door opener motor. 1. Press and hold the program button on the garage door opener motor until both blue indicator lights turn on. 2. Release the program button. Only the smaller round indicator light should be on. 3. Press and release the program button. The larger purple indicator light will flash. Note: The next two steps must be completed in 30 seconds. 4. Press and release the previously programmed button on the Genie Intellicode 2 hand-held transmitter. Both indicator lights on the garage door opener motor unit should now flash purple. 5. Press and hold the previously programmed button on the visor for two seconds. Repeat this step up to three times until the garage door moves. Programming is now complete. Clearing a HomeLink Device To erase programming from the three HomeLink buttons press and hold the two outer HomeLink buttons until the indicator light begins to flash. The indicator light will begin flashing in 10-20 seconds. When this happens, release both buttons. You have now erased the programming, and the indicator light should blink slowly to indicate the device is in train mode when you press any of the three HomeLink buttons. E142662 128 F150 (TF6)