2014 Ford F150 SuperCrew Cab Owner Manual Printing 1 - Page 151

Transmission Column-shifter 1. Apply the parking brake. Turn the ignition key to the off position, then remove the key. Move the steering column to the full down and full rearward position (toward the driver 's seat). Remove the gearshift lever boot. Place fingers into hole where the gearshift lever boot was removed from and pull top half of shroud up and forward to separate it from the lower half of the shroud. There is a hinge at the forward edge of the top shroud. Roll the top half of the shroud upward on the hinge point to clear the hazard flasher button, then pull straight rearward toward the driver 's seat to remove. Remove the top half of the shroud. Remove the three fasteners under the column that secure the lower shroud half to the column. 2. 3. 4. E163186 8. Apply the brake and move the gearshift lever into N (Neutral). 9. Start the vehicle. Perform Steps 4 through 8 in reverse order, making sure to engage the hinge pivots between the upper and lower halves of the shroud. Keep slight pressure in the forward direction as the halves are rotated together. Floor-shifter 1. Apply the parking brake. Turn the ignition key to the off position, then remove the key. 2. Starting at the rear of the trim panel, using a screwdriver (or similar tool) carefully pry up the trim panel from rear attachments and disconnect it from the console to expose the inside of the gearshift. 5. 6. E163185 7. Pull the lock lever into the full unlocked position and remove the lower shroud cover by pulling the lever handle through the slot in the cover. E166929 149 F150 (TF6)