2014 Ford F150 SuperCrew Cab Owner Manual Printing 1 - Page 216
2014 Ford F150 SuperCrew Cab Manual
Page 216 highlights
Roadside Emergencies HAZARD WARNING FLASHERS Note: The hazard warning flashers will operate when the ignition is in any position or if the key is not in the ignition. If used when the engine is not running, the battery will lose charge. As a result, there may be insufficient power to restart your engine. The hazard flasher control is located on the instrument panel E142663 by the radio. Use it when your vehicle is disabled and is creating a safety hazard for other motorists. • • Press the flasher control and all front and rear direction indicators flash. Press the flasher control again to turn them off. JUMP-STARTING THE VEHICLE WARNINGS The gases around the battery can explode if exposed to flames, sparks, or lit cigarettes. An explosion could result in injury or vehicle damage. Batteries contain sulfuric acid which can burn skin, eyes and clothing, if contacted. Use only an adequate-sized cable with insulated clamps. Preparing Your Vehicle Note: Do not attempt to push-start your automatic transmission vehicle. Automatic transmissions do not have push-start capability. Attempting to push-start a vehicle with an automatic transmission may cause transmission damage. Note: Use only a 12-volt supply to start your vehicle. Note: Do not disconnect the battery of the disabled vehicle as this could damage the vehicle's electrical system. Park the booster vehicle close to the hood of the disabled vehicle, making sure the two vehicles do not touch. Turn all accessories off. FUEL SHUTOFF WARNING Failure to inspect and, if necessary, repair fuel leaks after a collision may increase the risk of fire and serious injury. Ford Motor Company recommends that the fuel system be inspected by an authorized dealer after any collision. In the event of a moderate to severe collision, this vehicle is equipped with a fuel pump shut-off feature that stops the flow of fuel to the engine. Not every impact will cause a shut-off. Should your vehicle shut off after a collision, you may restart your vehicle by doing the following: 1. 2. 3. 4. Turn the ignition off. Turn the ignition to crank. Turn the ignition off. Turn the ignition on again to re-enable the fuel pump. Connecting the Jumper Cables WARNING Do not attach the cables to fuel lines, engine rocker covers, the intake manifold or electrical components as grounding points. Stay clear of moving parts. To avoid reverse polarity connections, make sure that you correctly identify the positive (+) and negative (-) terminals on both the disabled and booster vehicles before connecting the cables. 214 F150 (TF6)