2014 Ford F150 SuperCrew Cab Owner Manual Printing 1 - Page 63

Security 1. 2. Insert the first previously programmed coded key into the ignition. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than 10 seconds. Switch the ignition off and remove the first coded key from the ignition. After three seconds but within 10 seconds of switching the ignition off, insert the second previously coded key into the ignition. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than 10 seconds. Switch the ignition off and remove the second previously programmed coded key from the ignition. After three seconds but within 10 seconds of switching the ignition off and removing the previously programmed coded key, insert the new unprogrammed key into the ignition. Switch the ignition from off to on. Keep the ignition on for at least six seconds until you hear the door locks cycle. Remove the newly programmed coded key from the ignition. The direction indicators flash and the horn sounds if the system triggers while the alarm is armed. Take all remote controls to an authorized dealer if there is any potential alarm problem with your vehicle. 3. 4. Arming the Alarm The alarm is ready to arm when there is not a key in the ignition. Electronically lock the vehicle to arm the alarm. The direction indicators flash once after you lock the vehicle. This indicates the alarm is in the pre-armed mode. It will fully arm in 20 seconds. 5. 6. Disarming the Alarm Disarm the alarm by any of the following actions Press the power door unlock button within the 20-second pre-armed mode. Unlock the doors with the remote control or keyless entry keypad. Switch the ignition on or start the vehicle. Use a key in the driver door to unlock the vehicle, then switch the ignition on within 12 seconds. 7. 8. 9. The key will start the engine if programming is successful. You can operate the remote entry system if the new key is an integrated keyhead transmitter. If programming was not successful, wait 20 seconds and repeat Steps 1 through 8. If you are still unsuccessful, take your vehicle to an authorized dealer. Note: Pressing the panic button on the remote control will stop the horn and signal indicators, but will not disarm the system. ANTI-THEFT ALARM (IF EQUIPPED) The system warns you of an unauthorized entry to your vehicle. It triggers if any door or the hood opens without using the key, remote control or keyless entry keypad. 61 F150 (TF6)