Adaptec 29320A-R User Guide - Page 101
Completing a Fresh Windows NT 4.0 Installation From CD
UPC - 760884155226
View all Adaptec 29320A-R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Installing the SCSI Driver for Windows NT 4.0 8 To add other host adapters that are not part of the Ultra320 Family, press S and repeat from Step 5 for each additional adapter and insert the appropriate driver disk. The Adaptec Ultra320 Family host adapters use the same driver; it is not necessary to install the driver again. 9 Press Enter to continue with the Windows NT 4.0 operating system setup. Follow the instructions on-screen and in the Windows NT 4.0 documentation to complete the installation. Completing a Fresh Windows NT 4.0 Installation From CD 1 Insert the Windows NT 4.0 CD into the CD-ROM drive. 2 Start your system. Press the F6 key when you see the following message: Setup is inspecting your computer's hardware configuration... If you do not see this message, your system may not be setup to boot from a CD. You will need to install from floppy disks. See Completing a Fresh Windows NT 4.0 Installation From Floppy Disk on page 9-2. 3 When prompted, press S to specify an additional device. 4 Press Enter to select Others; insert the Ultra320 disk for Windows in your floppy disk drive. 5 Using the arrow keys, select the following driver and press Enter: Adaptec Ultra320 Family PCI SCSI Controller (NT4.0) 6 To add other host adapters that are not part of Ultra320 Family, press S and repeat from Step 4 for each additional adapter and insert the appropriate driver disk. The Adaptec Ultra320 Family host adapters use the same driver; it is not necessary to install the driver again. 7 Press Enter to continue with the Windows NT 4.0 operating system setup. Follow the instructions on-screen and in the Windows NT 4.0 documentation to complete the installation. 9-3