Adaptec 29320A-R User Guide - Page 123
Installing the Driver When Installing UnixWare, Open Unix
UPC - 760884155226
View all Adaptec 29320A-R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 123 highlights
Adaptec Ultra320 SCSI Cards User's Guide If you are performing a first time UnixWare/Open Unix installation, see Installing the Driver When Installing UnixWare/Open Unix on page 11-2. If UnixWare/Open Unix is already installed in your system, see Installing the Driver When UnixWare/Open Unix is Already Installed on page 11-4. If you are performing a first time OpenServer installation, see Installing the Driver When Installing OpenServer on page 11-8. If OpenServer is already installed in your system, see Installing the Driver When OpenServer is Already Installed on page 11-8. Note: UnixWare/Open Unix, and OpenServer installation requires that the host adapter driver be installed from a disk. See Appendix D, Creating Driver Floppy Disks for UnixWare/ Open Unix, and OpenServer driver disk creation. Installing the Driver When Installing UnixWare/ Open Unix To install the adpu320 driver at the same time you install UnixWare/Open Unix: 1 Insert the Install CD of the UnixWare/Open Unix package into the boot CD-ROM drive. Start your computer. Wait for the first UnixWare/Open Unix installation screen and prompt to appear, then follow the on-screen instructions. 2 When prompted to either Install Host Bus Adapter Drivers or Continue Installation, select Install Host Bus Adapter Driver and press Enter. 3 Insert the Ultra320 driver disk for UnixWare/Open Unix into the primary floppy disk drive and press Enter (you cannot load drivers from a secondary floppy disk drive). (See Appendix D, Creating Driver Floppy Disks for information on creating driver floppy disks.) As the driver loads, a message identifying the installed host adapter briefly appears on screen. The installation process determines which device drivers on the disks are needed. 11-2